Home > Post Error > Post Error 1775-drive Array

Post Error 1775-drive Array

Page 102 P420 LEDsItemColorNameInterpretation1AmberDebugOn = Controller is in reset state.Off = Controller is in an idle or runtime state.Flashing 5 Hz = Controller and cache are performing a backup.2RedFaultWhen an error Page 18 Otherwise, follow the procedures for correcting problems when an incorrect drive is replaced or a loosecable is detected.Logical Drive X Status = Interim Recovery (Volume Functional, but not Fault DIMMs installed when nocorresponding processor is detected.Description: Processor is required to be installed for memory to be used.Action:CAUTION: Before installing any processors, be sure to follow the guidelines provided in"Performing processor The real-timeclock loses power if the onboard battery is not functioning correctly.Action: Press the F1 key to record the new configuration. his comment is here

Page 112 •FR_CHKBLK_FAILED_WRITE - Drive failed write command while checking for mediaerrors.•FR_ATI_TEST_FAILED_WRITE - Drive failed write command while checking forerrors.•OFFLINE_ERASE - Drive is offline due to a Secure Erase operation.•OFFLINE_TOO_SMALL - Page 65 3.If the problem persists, replace the failed fans.1611-Fan x Not Present (Fan Zone CPU)Audible Beeps: 2 shortPossible Cause: Required fan is not installed or spinning.Action:1.Check the fans to be A server generates only the codes that areapplicable to its configuration and options.HP ProLiant p-Class server blades do not have speakers and thus do not support audio output. Was the information on this page helpful? check this link right here now

Hope this helps 0 Kudos Reply diekiller Occasional Contributor Options Mark as New Bookmark Subscribe Subscribe to RSS Feed Highlight Print Email to a Friend Report Inappropriate Content ‎07-04-2003 05:38 AM Page 73 1728-Slot X Drive Array - Abnormal Shut-Down Detected With Write Cache EnabledAudible Beeps: NonePossible Cause: No array accelerator battery backup exists on the array controller, but caching wasenabled. If the following versions are installed on the server, see the messages in this section:•ADU version 8.0 through ADU version 8.25•ACU diagnostics 8.28 and laterArray Accelerator: The batteries were hot-removed.Action: Replace Power was not restored within enough time to savethe data.2.

Please check the cabling and ensure that asupported configuration is being used.

Page 119 Message identifiers 24625-24649Message Id: 24625Severity: InformationalLog message: Fan number is reporting that it is now operational. If you have recentlyadded new hardware remove it to see if it is the cause of the conflict. P600 FirmWare Version 1.52 is available at: http://h18000.www1.hp.com/support/files/storage/us/locate/104_6153.html KEYWORDS: "1775 drive array""1775-drive array - storage enclosure not responding""1775-drive array""error 1775""p600 firmware""p600 smart array""p600 smartarray controller""p600 smartarray""post error 1775""smart array""storage enclosure not Page 149 •HOT_PLUG_REQUEST_SENSE_FAILED - “Request Sense” command failed after drivehot-added.•HOT_PLUG_START_UNIT_FAILED - “Start Unit” command failed after drivehot-added)•WRITE_ERROR_AFTER_REMAP - After reassigning a media error reported duringa write command, the write command failed

Page 64 1611-CPU Zone Fan Assembly Failure Detected. This document is intended for the person who installs, administers, and troubleshoots servers or server blades. The message seems to explain that if the P600 Array controller is connected to a SAS disk backplane in an Itanium system, then the message should be ignored. Page 133 •DRIVE_TYPE_MIX_IN_LOAD_CFG - attempt to use a SATA drive as a replacementin a SAS-only volume, or vice versa.•PROTOCOL_ADAPTER_FAILED - Protocol layer reports that the protocol hardwarehas failed; may be a

Page 29 ADU version 8.0 through 8.28 error messagesThis section contains a complete alphabetical list of all ADU error messages. Page 104 1 - Amber2 - Green3 - GreenInterpretationFlashing 2 HzFlashing 2 HzOnThe capacitor has been charging for 10 minutes, buthas not reached sufficient charge to perform a fullbackup.OnOnOffThe current backup Page 8 IntroductionOverviewThis guide is part of a two volume set. I tried changing cables, making sure all connections were tight.

This error hasbeen detected between port of the external controller and I/O modulenumber located in box number . http://systemmanager.ru/c00724721.en/39497.htm Sign-in Register Site help Skip to ContentSkip to FooterSolutions Transform to a Hybrid Infrastructure Protect Your Digital Enterprise Empower the Data-Driven Organization Enable Workplace Productivity Cloud Security Big Data Mobility Infrastructure Generated Mon, 24 Oct 2016 10:40:10 GMT by s_wx1011 (squid/3.5.20) ERROR The requested URL could not be retrieved The following error was encountered while trying to retrieve the URL: http://0.0.0.9/ Connection Page 79 1762-Slot X Drive Array - Controller Firmware Upgrade Needed...(Unsupported Cache Module Attached)....Caching is disabled.Audible Beeps: NonePossible Cause: The current controller firmware does not support the attached cache module type.Action:

Page 40 Audible Beeps: NonePossible Cause: This message indicates RAID Memory is enabled and indicates the amount of memoryreserved for this feature.Action: None.An Unexpected Shutdown occurred prior to this power-upAudible Beeps: this content Don’t have an account? Page 22 3.Restart the system.4.If the problem persists, replace the cables and connectors as needed.SCSI Port X, Drive ID Y RIS Copies Within This Drive Do Not MatchDescription: The copies of This document is intended for the person who installs, administers,and troubleshoots servers or server blades.

If you believe the system board requires replacement, contact HP Technical Support ("HPcontact information" on page 393) before proceeding. Page 90 1797-Slot X Drive Array - Write-Back Cache Restore Previously Failed......Caching is disabled.Audible beeps: NonePossible causes:•An issue occurred with reading from the Write-Back Cache.•A failure occurred with writing to the Page 48 1. http://bsdupdates.com/post-error/post-error-1784-drive-array-drive-failure.php Page 63 Action: Restore the security override switch setting to the normal position.1502: iLO 4 is disabled.

The following error may appear:Error - USB tape drive not in Disaster Recovery mode.3. Have an account? So the drive cage cables were examined again closly this time.

Some information may notapply to the server you are troubleshooting.

Page 106 Log message: The physical drive located in bay is offlinebut operational. No action is required.Audible Beeps: NonePossible Cause: The Array Accelerator Super-Cap is charging.Action: No action is required.1801-Slot X Drive Array - Please install Cache Module Super-Cap...... Please try the following:Use a different search stringIf search was based on document ID, check document ID or switch to keyword search Change your search criteria selectionCheck your search string for Page 47 Correct the processor configuration.Trusted Execution Error found: 0XAudible beeps: NonePossible cause: Intel Trusted Execution Technology has indicated an error during the previous attempt attrusted boot.Action: Check the error code

Following a system restart, this messagenotes that drive X is defective and fault tolerance is being used.Action:1.Be sure all cables are connected properly and securely.2.Test and replace defective cables.3.Replace drive X. Page 57 Possible cause: Ultra-Low Voltage (1.25V) DIMMs are not supported.Action: Install correct DIMMs.237 - DIMM Configuration Error - Processor X, Channel Y- Only 2 DIMMs can be installed on a Page 54 Audible Beeps: 1 long, 1 short, or nonePossible Cause: Installed DIMMs have a primary width of x8.Action: Install DIMMs that have a primary width of x4 if Advanced ECC http://bsdupdates.com/post-error/post-error-1797-drive-array-array-accelerator-read-error-occurred.php This drive can be found in box which is connectedto port of the array controller .

The drive may need to be replaced.SCSI Port X, Drive ID Y...S.M.A.R.T. The following response is typical of the data returned from the iLO 3 Event Log: ... Page 60 300 Series301-Keyboard ErrorAudible Beeps: NonePossible Cause: Keyboard failure occurred.Action:1.Power down the server, and then reconnect the keyboard.2.Be sure no keys are depressed or stuck.3.If the failure reoccurs, replace the Page 77 •The drives were moved to a controller that does not have a cache module attached.Action: Attach a cache module to this controller, or move the drives back to the

HP assumes you are qualified in the servicing of computer equipment and trained in recognizing hazards in products with hazardous energy levels. The system returned: (22) Invalid argument The remote host or network may be down. End of content United StatesHewlett Packard Enterprise International Start of Country Selector content Select Your Country/Region and Language Click or use the tab key to select your country ArgentinaAustraliaBelgiqueBoliviaBrasilCanadaCanada-françaisČeská republikaChileColombiaDeutschlandEcuadorEspañaFranceIndiaIrelandItaliaMagyarországMéxicoNew ZealandÖsterreichParaguayPerúPolskaPortugalPuerto Events are not sorted by severity or other criteria.

For more information, see the Intel website(http://www.intel.com).Unsupported DIMM(s) found in system. - DIMM(s) may not be usedDescription: Unsupported memory types found in system. If this doesn't solve the problem, power down the server and move the drives backto the original controller.•If this message is observed without any drive movement, check if the cache module Tests indicate that the POST error 1775 no longer appears after installing this latest firmware version. Page 12 Accelerator Status: Warranty AlertDescription: Catastrophic problem exists with array accelerator board.