Home > Lens Error > Powershot A1000 Is Lens Error

Powershot A1000 Is Lens Error

Contents

Switched out the battery. Then I googled the problem and found this site. Once these materials work their way into the lens mechanism, that's all she wrote. I definitely didn't drop it because I was holding it when it happened. have a peek at these guys

Does using Mold Earth to trip someone break its rule against causing damage? Did it 3 times and now I do not get a new camera .. DDoS ignorant newbie question: Why not block originating IP addresses? It worked incredibly well on my Canon DMC-FX33 (which we had taken to the beach and obviously taken on a few sand particles) - freeing the lens in seconds with no

Canon Powershot Lens Error

Still dead. Sand, gunk, case fibers, etc... I did what you said and fixed my camera, I thought I had lost forever!

  • My work mate is very surprise but also very happy to know that her camera isn't a write-off working 05/31/2013 by Warren Amazingly, it worked for my Canon PowerShot SD780.
  • Two internal screws hold the lens cap assembly on.
  • My wife's Sony Cybershot seemed hopelessly stuck.
  • If needed I am willing to do it again and take some photos.
  • June 1, 2010 at 7:34 AM julie p said...
  • If you notice that the gap is not even all the way around the lens, the problem should be easy to fix.
  • when i droped my camera while using it , the lens got stuck and would not open and the camera wouldn't work .I just thought I broke it.
  • A camera owner that suffers this problem may have no recourse for having the camera repaired.
  • The lense will not close!

p.s. Unfortunately, the lens cover started sticking again, so I began removing the silver-colored outer ring with the lens fully extended using a razor blade. I used a Q-tip & Cigarette lighter fluid to clean it. Canon G10 Lens Error Restart Camera i just wish i would have found it wiht my last camera :/ but i fixed this one with the paper thing and the vacuum!!

Your paper trick worked. Canon Camera Lens Error Will Shutdown Automatically In fiddling with it, the outer ring came off. The satisfaction of the fix (not to mention the money and time saved on a professional repair) almost made the whole experience of a jammed lens rather enjoyable. (almost) July 7, It was fine.

When I first got it, the lens wouldn't work at all but now it's working sometimes. Canon G11 Lens Error Restart Camera Inserting this cable ensures that the camera's LCD screen remains off during the start process. I sent them my video but since they can't post it, I thought to put it up myself. Sometimes the lens won't even move.

Canon Camera Lens Error Will Shutdown Automatically

There was a visual dent on the outer lens, After performimg steps 1 through 7, minor force was applided to the outside of the lens while turning on the power, it https://support.usa.canon.com/kb/index?page=content&id=ART105302 after i opened it i saw a little rusty spring out of place. Canon Powershot Lens Error So have to turn it on by the power button which works successfully. Canon G12 Lens Error Works beautifully, I found a plastic screw on lens hood with cover on ebay, much better solution and never have to worry about a sandkorn or whatnot to paralyze the otherwise

I have a canon a520, but our lens got stuck retracted and not extended. More about the author I just saved about $200 by using the vacuum trick! I tried the paper trick and it did retract however its still sticking and coming back with the error after I turn it on and off a couple times it resticks. replied6 years ago. Canon Powershot A4000 Lens Error

The lens will get stuck in the extended position, and refuse to move either to focus the lens or to retract when powered off. The springs measures 1.2mm diameter, the wire is 0.25mm and the closed length is 2mm so they are teeny. I read the suggestions on this site, found opening the lens, taking out the battery, then sliding a fingernail under the slightly bent-in middle ring fixed my problem. http://bsdupdates.com/lens-error/powershot-tx1-lens-error.php I put the batteries back and turned on the power and the lens cover works perfectly.

But as mentioned in the right hand "Please Read This!" column:"WHAT YOU READ HERE IS NOT PROFESSIONAL ADVICE. Canon G16 Lens Error Search: About Dan York Subscribe Or enter your email address: Contact Info Email: [emailprotected] Telephone: +1-802-735-1624 Skype: danyork Twitter: @danyork Google+ LinkedIn License This work is licensed under a Creative Commons But when I see the LCD carefully, I can see some of the bright object.

Thanks again!

Restarting the camera doesn't do anything. I'm going to remember this one! Thank you!!! Lens Error Canon S100 June 13, 2012 at 3:14 PM Anonymous said...

Switched out the battery. Thanks for this!Mine got fixed with the paper thing and using the hair dryer!Such a great help! A protruding 1.5mm lever on adjacent part rotates an outer ring to make either one spring act or the other. news alsautoandappliance 12.806 προβολές 1:36:27 Powershot G10 Objektivreparatur / Lens error repair - Διάρκεια: 6:14.

They'd be the place for help with this one, best of luck. Step 2: Please assign your manual to a product: About Advertising About Us Blog Careers News & Media Help Contact FAQ Partners Privacy Policy Terms Community Forums Recent Q&A Top Experts But nothing bad happened. None of these methods involve opening the camera, although some have potential to cause other damage to the camera if excessively done.

It's functioning perfect now. Hi,The two links below may help you solve your problem. Restart Camera" - Canon S100 Powershot - Διάρκεια: 1:32. After cycling on & off several times, it works fine.

I've tried to pull the lens open with my nails, and still no luck... so i tried taking out the batteries and hit it on the table (read on other sites) then i gently turned the end of the lens (my lens was stuck out) the responsibility and choice is entirely yours if you whack your camera too hard and break it...) Woke up this morning to find that my Canon SD1000 point-and-shoot camera that I Yes No Voted Undo Score 0 Cancel Add a comment 0/1024 Cancel Post comment Are you sure you want to delete this zzzzzz?

Please enable JavaScript if you would like to comment on this blog. Am sure that this is what caused it to loosen from the caulk. it works like a charm now !! Also, when I try to take a picture and or video, it says card error.

I tried the tapping techniques etc but resorted quickly to prying off the lense cover. Neither compressed air nor paper strip helped. Some cameras might not beep or show any message, depending on the manufacturer and model. Or the camera has been powered on, but the lens had been blocked preventing its extension.

Who knows, you might get lucky.