Home > Beep Codes > Post Error 3 Long Beeps

Post Error 3 Long Beeps

Contents

When troubleshooting further, refer to the section Resolving beep codes. p.36. Follow that diagnosis above. 4 Short Beeps Basically the same thing as 2 beeps. Startup tone, drive spins, no video Problem with video controller. check my blog

Replace the motherboard if it is soldered in. 7 Short Beeps Your CPU broke overnight. Wikipedia® is a registered trademark of the Wikimedia Foundation, Inc., a non-profit organization. If video is working, you'll see an error message. Make sure that the contacts on the memory and the socket are clean. http://www.computerhope.com/beep.htm

3 Long Beeps Intel Motherboard

During POST, the BIOS must integrate a plethora of competing, evolving, and even mutually exclusive standards and initiatives for the matrix of hardware and OSes the PC is expected to support, Step 2 - Jumps to ROM code in diagnostic card (if found) Step 3 - Disables and clears all DMA and interrupts. As the PC platform evolved into more of a commodity consumer device, the mainframe- and minicomputer-inspired high-reliability features such as parity memory and the thorough memory test in every POST were

The pattern repeats until the computer is powered off. Try yanking out the cards one by one to isolate the culprit. Video error (no add-in graphics card installed) Reseat add-in graphics card. Hp Beep Codes When troubleshooting further, refer to the section Resolving beep codes.

note: Not all codes shown and codes shown might vary. Asus Beep Codes Low 1-1-2 Your motherboard is having problems Low 1-1-3 This is an Extended CMOS RAM problem, check your motherboard battery, and motherboard. Step 5 - Checks the general hardware configuration. http://www.intel.com/support/motherboards/desktop/sb/cs-010249.htm Good Luck Report yousaf khan- May 14, 2012 09:02AM its not ram problem ram is working on other computers.

Check if you are able to get the display from the onboard VGA. Post Beep Codes None of the PSU connectors to the mainboard have any signs of burning / shorting out that I can see. This page requires Javascript. if it is not try to reconnect every cable slowly but surely to see what was the problem.

Asus Beep Codes

If it were my PC, this cooler and a couple of these fans would be on order straight away, just to shut the thing up a bit whilst remaining on the http://www.pchell.com/hardware/beepcodes.shtml Use these codes to help troubleshoot problems related to system startup or flashing BIOS memory (such as in BIOS upgrades). 3 Long Beeps Intel Motherboard Retrieved 19 October 2013. ^ A website with PC BIOS, POST and BEEP code information ^ [1] ^ [2] ^ http://www.amiga.org/forums/archive/index.php/t-37543.html External links[edit] POST as part of the BIOS - by Gigabyte Beep Codes Take it to the shop. 3-1-_ One of the chips on your motherboard is broken.

The original IBM PC could be equipped with as little as 16 KiB of RAM and typically had between 64 and 640 KiB; depending on the amount of equipped memory, the http://bsdupdates.com/beep-codes/post-error-4-long-beeps.php If, however, the system supports power saving or quick boot methods, the BIOS may be able to circumvent the standard POST device discovery, and simply program the devices from a preloaded eSupport.com is the world's oldest and largest provider of BIOS Upgrade technology with nearly 15 years of unparalleled excellence in the industry. Am I on the right track? 3 Short Beeps

Then the computer continues to boot. Visible LED blink patterns Visible blink patterns are displayed via the front panel power LED. Support Forum Join the conversation! http://bsdupdates.com/beep-codes/post-error-2-long-beeps.php There are websites which collect codes for many BIOSes.[2] Original IBM POST beep codes[edit] Beeps Meaning 1 short beep Normal POST – system is OK 2 short beeps POST error –

However, because of the wide variety of different computer manufacturers with this BIOS, the beep codes may vary. Beep Codes List first unseat the video card and then reseat it and reapply power to see if problem is fixed. The pattern repeats until the BIOS update is complete.

Good Luck Report cevikatmaca- Nov 4, 2012 10:36AM Yousaf what happened at the end of the story?

If it doesn't help, reseat the chip that controls the keyboard, if it isn't soldered in. Check for a faulty memory module by trying the memory in a known good system. Memory error Reseat the memory. 1 Long 2 Short Beeps On the screen, if working, will be the Sad Mac icon, along with two hexadecimal strings, which can be used to identify the problem.

For a cold boot, for example, it may need to execute all of its functionality. The pattern repeats once. Macintosh startup tones Tones Error Error Tone. (two sets of different tones) Problem with logic board or SCSI bus. More about the author You need a new motherboard. 1-2-2 The motherboard is bad. 1-2-3 The motherboard is bad. 1-3-1 You'll need to replace the motherboard. 1-3-3 You'll need to replace the motherboard. 1-3-4 The

With this audio code in hand, you can determine what part of the system is having problems and find a solution. If all of the above steps have been tried and the beeping sound still exists, refer to beep code table specific to the motherboard of the computer, or Contact HP (in If the screen remains a light gray colors and the tests continue, the hardware is OK. Contact support Give Feedback Did you find this information useful?

Actually, maybe just a tiny bit won't hurt.. ^-^ edit: after just 8 minutes of work at stock speed, Prime95 has the CPU at 65degC so I might leave the clocks Is everything connected? Safari Chrome IE Firefox Support Navigation Support Support Home Drivers and Software Product Specifications Warranty Warranty Center Track Warranty Status Submit a Warranty Request Support Community Contact Us Support by Product If an error occurs, the system halts.

I'd consider tinkering with the clocks but I can't justify it on stock cooling. Linux, use port 80 for I/O timing operations. If they are dismal I will consider reapplying thermal paste to the CPU/GPU as required. The following beep codes can occur while restoring, flashing or updating the BIOS: Beeps Description 1 short beep Legacy floppy drive or CD/DVD drive not detected 2 short beeps Floppy diskette

Played a variety of formats with no problem. Register now Not a member yet?